When using LNEYA rapid temperature control system, regular maintenance plans can be made and regular maintenance can be carried out to reduce the failure rate.
Rapid temperature control system – cleaning the condenser dust of the thermal cycle controller
The condenser should be maintained regular monthly. The dust attached to the condenser heat net can be sucked away by vacuum cleaner or sprayed with high-pressure air.
Examining the over-temperature protector of the rapid temperature control system – thermal cycle controller
When running the equipment, the maximum setting value of over-temperature protection is increased by 20 degrees to 30 degrees. When the temperature in the equipment rises to the set point of over-temperature protection, the power supply of the heater will be stopped, the ‘OVERHEAT’ warning light will be on and the fan will still be running. If the equipment will be running for a long time and left unattended, be sure to check whether the over-temperature protector is properly set before running. Please setting the value of over-temperature protector as 120 degrees.
Rapid temperature control system – thermal cycle controller internal and external cleaning and maintenance
Clean out the internal impurities before operating the machine. The switch board must be cleaned at least once a year, and the dust can be removed by vacuum cleaner. The outside of the machine must also be cleaned more than once a year, cleaning with soap and water.
Inspection and maintenance of refrigerant for rapid temperature control system – thermal cycle controller
If the equipment is water-cooled, it should be replaced once a month to ensure the water quality is clean. The equipment should be cleaned once a month to ensure the water flow is smooth. Other refrigerants also need regular inspection and replacement.
in general, the maintenance plan is essential. Users can make maintenance plan according to their own plan.